Error code 503 while it was programing

[easymon]

Hey guys need help was programing a new file in on my 18 ran. While flashing with v2 went through the erase process and started programing then got 503 code . Now the flash scan won't stay connected to the PC while it's programing there. So how do I reset my flash scan? To make things worse my truck is disabled now and I won't program since the ECM is already erased please help

Sent from my ONEPLUS A6013 using Tapatalk

[easymon]

Hey guys need help was programing a new file in on my 18 ran. While flashing with v2 went through the erase process and started programing then got 503 code . Now the flash scan won't stay connected to the PC while it's programing there. So how do I reset my flash scan? To make things worse my truck is disabled now and I won't program since the ECM is already erased please help

Sent from my ONEPLUS A6013 using TapatalkGot it back up and running had to use pass through and use stock file then reinstall modded file. Not sure why losing connection bbx .

Sent from my ONEPLUS A6013 using Tapatalk

[easymon]

Could there be a problem with the new patches ? Everything was fine until updated firmware now v2 losses connection can't write files to it pass through working need some insight. Codes I get are 0001 -0002. PS I even uninstalled and reinstalled EFI live

Sent from my ONEPLUS A6013 using Tapatalk

[easymon]

Error according to the error code chart this has to do with drivers says contact EFI.https://uploads.tapatalk-cdn.com/20190920/ae9b04066018547fd9ee55cef4b06bd9.jpg

Sent from my ONEPLUS A6013 using Tapatalk

[tylerltr450]

Did you reinstall the usb driver?

[easymon]

Resolved just bad USB cable.

Sent from my ONEPLUS A6013 using Tapatalk