PDA

View Full Version : Trying to log pressure sending unit



Fastorange
September 22nd, 2019, 09:13 AM
I wanna start off by saying, i have been searching for a few days now, and trying to read as much as i can.. i have some isspro ev2.. i have read the tutorial on setting it up for an ls1. But it also referees to a v1, I'm guessing that its basically the same.. however i am very unsure, when it comes to configuring the pid in efi live.. i find the pid in the tab, it shows psi, but no values. Could someone point me in the correct directions?

If i tap into the 5v signal wire and run it to the v2 and connect it to the positive side on the orange tee, on a/d input 1 do i also need to run a ground wire to the v2 as well?

joecar
September 29th, 2019, 10:20 PM
You want to log the oil pressure sender...?

The problem is when you tap into its signal, you may change the signal... you could try it and see... I would add an additional oil pressure sensor (probably on the oil filter housing).

BTW: it looks like your emails to me are getting filtered out (my email provider blocks @gmail.com and @yahoo.com)... send me a test email.

Fastorange
September 30th, 2019, 12:11 AM
Sent