C0558 hard code after reflashing for a gear change

[mysunnshine]

So I went and changed the gears in my 2005 Yukon yesterday from 3.73 to 4.56 gears and after making the initial calibration change for the gear ratio, I got a hard C0558 code which is "calibration Data Not Programmed/Learned". I have tried to put the original cal back in to see if that would revert it back but no go. Any ideas of what happened when I flashed the ECU? I have not had this code at all before flashing it yesterday.

[pinstripebob]

Do you have separate engine and transmission tunes, and if so did you make the change in both of them? Can you post your tune files?

Sent from my Pixel 3 using Tapatalk

[mysunnshine]

It's a LS1b ecu so both the engine and trans cals are within the same ECU and are not separate.

[joecar]

C code is from either body/chassis controller or ABS controller...

[mysunnshine]

I saw the code description when I pulled the code. I was just trying to figure out how the ABS module lost it's cal info after I changed the gear ratio in the ECU.

[GMPX]

It didn't it must know there is now a mismatch between the ECM and ABS.

[mysunnshine]

I tried to put back the original call and the code is always there though. With that, I have to guess that the ABSinfo got erased with the reflash.