PDA

View Full Version : VE Tuning - Running logged file with tune open to VE table



Bill00Form
November 9th, 2019, 05:15 AM
Just wanted to confirm if the cell highlighted in the tune file is always the cell being referenced by the car's computer.

I am using the custom calibration number 3.

When I do this only the first column is being highlighted.

Thanks,

Bill

ScarabEpic22
November 10th, 2019, 11:46 AM
The LS1_Link file for the controller must not be mapped for that particular OS. Edit the file in C:\Program Files (x86)\EFILive\V7.5\Configuration and make sure the table you're looking at has the correct values mapped in the file.

Bill00Form
November 10th, 2019, 11:45 PM
Thanks ScarabEpic22. I will try to look into that as well.

joecar
November 11th, 2019, 04:46 PM
Post pic.

Check units are same between logged pid and table columns.

Bill00Form
November 12th, 2019, 04:20 PM
Thanks Joecar. I will verify.

Bill00Form
November 16th, 2019, 10:54 AM
joecar you were exactly right. Even though my map showed the same units the pid default was set to SAE. When I made that change it was consistent with the map log. Thanks

joecar
December 8th, 2019, 02:21 PM
Good deal, thanks for confirming.