CME (A9134) Turbo Min-Max Position CSP Enable

[Twistedshafts]

Under the CM2350B user guide it says under each CSP5 file there should be a parameter box for A9134. This would allow you to have that tune only run off of the min/max in that tune file and not the four alternate files. Was this removed? Will the tune still only run off of the min/max in that tune file? I notice in the files you only have one min/max and in previous model PCM and ECM there were two under each tune file.

[GMPX]

Ooops, it looks like some documentation from the CMC (CM2100) CSP5 was copied into that document, this is not applicable for the 2010+ ECM's, sorry about the confusion.

[Twistedshafts]

Okay no problem thank you for letting me know. Is there any way to get the pro tuning software?

[GMPX]

For Cummins ECM's a pro-license doesn't give you any extra functions.
Really the only thing it allows people to do is for GM vehicles they can overwrite operating systems in controllers that we would normally flag as incompatible (which sometimes might be ok, other times it'll brick/corrupt the ECM).

[Twistedshafts]

Okay, thank you for letting me know. ��