pasting values in to Calc_Pids

[s10mods]

IS there a good way to paste values from the tune tool to a calc_pids file other than one at a time? I need to update my b4901 section and I did it one at a time and noticed I made a small mistake and just wondered if there was a simpler way.

This was the original from calc_pids

*CLC-00-260
factor 0.0 1.0 .4 "lookup({SAE.MAF.gps}, 0,0.60010, 10,0.17139, 20,0.12842, 30,0.08594, 40,0.08106, 50,0.07129, 60,0.06201, 70,0.05469, 80,0.04736, 90,0.04297)"

My b4901 is

*CLC-00-260
factor 0.0 1.0 .4 "lookup({SAE.MAF.gps}, 0,0.799805, 10,0.512207, 20,0.442871, 30,0.412109, 40,0.391113, 50,0.374023, 60,0.358887, 70,0.344727, 80,0.331543, 90,0.318359, 100,0.305664, 110,0.293457, 120,0.281250, 130,0.269531, 140,0.257324, 150,0.245605)"

Also do I need to add the additional lines from 90 to 150?

[aaronc7]

You could copy with labels, pasted into excel. Save as a CSV, open that with notepad and that would do most of the work. You'd still need to put commas between each data set.

Yes, keep the additional lines from 90 to 150