RC1
July 26th, 2020, 07:48 AM
I've got something really simple that seems to be kicking my butt here. At some point in the last few days my MAP readings have gone all crazy. I'm using the 12592525 GM 3 Bar, Linear/Offset settings are 312.00/-11.25 as always, and my minimum/maximum are set the same. I've checked the 5V supply to the sensor and it is good at 5.0V, and the Signal voltage shows at 1.7-1.8V. In Scan Data instead of seeing 100kpa I'm seeing 32kpa, which corresponds to the 1.8V Signal V if I were using a 1 Bar sensor. When I start the car, it goes to 0kpa, which of course messes with the Map/Baro Ratio. I've already installed a new spare Map sensor with the same results.
Somewhere along the line something has gone awry, but I'm not sure where to go next. Any help would be appreciated.
Somewhere along the line something has gone awry, but I'm not sure where to go next. Any help would be appreciated.