Log in

View Full Version : Modifying cal file for 10mm CP3 on LML


Dustin_360
January 1st, 2021, 04:11 PM
Hey Guys-

I'm installing an S&S 10mm CP3 on my truck (LBZ based) pump. I want to modify my cal file so I can drive it and make sure everything is ok before I get it tuned. Did some searches and it looks like I need to modify "Desired flow VS Current" table for the Fuel Pressure. Anyone have any additional guidance? Is there anything else I need to pay attention to?
blackshadow
January 12th, 2021, 06:59 AM
Hey Guys-

I'm installing an S&S 10mm CP3 on my truck (LBZ based) pump. I want to modify my cal file so I can drive it and make sure everything is ok before I get it tuned. Did some searches and it looks like I need to modify "Desired flow VS Current" table for the Fuel Pressure. Anyone have any additional guidance? Is there anything else I need to pay attention to?

Attached is a good baseline to start at that fleece posts with thier conversion kits.

https://www.fleeceperformance.com/media/wysiwyg/LML_CP3_MeUn_Scaling.pdf