Autovation
May 8th, 2021, 02:35 AM
I'm fighting a problem with an 80e swap. Here are the details. Also, I do this for a living and have tuned quite a few vehicles for myself and customers.
Also this isn't my first post. I couldn't get logged into my old account so after multiple tries I just created a new account.
This is my first dive into the T42
2007 Avalanche
E38
just rebuilt a 5.3, small cam and an On3 70mm turbo. Still working on the tune, but that will come once the trans is sorted out.
T42 originally 4L60e (original T42 cal attached)
swapped to an 80e that I rebuilt with a few mods.
Wiring changed to match 80e and tune for an 80e with the same OS and Cal ID (cal I started with attached)
I made a few changes to shift speed and RPM, but that's all. (cal also attached)
On my first drives I only had 3rd, 4th, and a very harsh lockup. Did some checking and I had 2 pins unseated form the TCM connector. Disassembled it and got that fixed.
Now it starts out in first if i drop it into manual low and goes through the gears manually. Come to a stop and have to go back through manually but no shifting in Drive.
Pulled the trans out, tore it down completely, reassembled it. Air checked everything, tested the solenoids (all electronics and harness are new), so I know for sure the trans is good. Wiring between trans and controller continuity checks good.
If someone with some expertise can take a look at the calibration to see if something is off that I'm not catching, I would greatly appreciate it.
Also this isn't my first post. I couldn't get logged into my old account so after multiple tries I just created a new account.
This is my first dive into the T42
2007 Avalanche
E38
just rebuilt a 5.3, small cam and an On3 70mm turbo. Still working on the tune, but that will come once the trans is sorted out.
T42 originally 4L60e (original T42 cal attached)
swapped to an 80e that I rebuilt with a few mods.
Wiring changed to match 80e and tune for an 80e with the same OS and Cal ID (cal I started with attached)
I made a few changes to shift speed and RPM, but that's all. (cal also attached)
On my first drives I only had 3rd, 4th, and a very harsh lockup. Did some checking and I had 2 pins unseated form the TCM connector. Disassembled it and got that fixed.
Now it starts out in first if i drop it into manual low and goes through the gears manually. Come to a stop and have to go back through manually but no shifting in Drive.
Pulled the trans out, tore it down completely, reassembled it. Air checked everything, tested the solenoids (all electronics and harness are new), so I know for sure the trans is good. Wiring between trans and controller continuity checks good.
If someone with some expertise can take a look at the calibration to see if something is off that I'm not catching, I would greatly appreciate it.