PDA

View Full Version : How to make use of a logged ve pid?



PHP INC.
March 15th, 2005, 02:36 PM
I haven't found anything to help me on this. What we are working on is a 1998 T/A with a 443 cu. in. LS1. I currently tuning with LS1 Edit, which I understand very well. I just got EFI Live V7 today and I am trying to use this data to setup a proper ve table. From what I read in other posts this should be simple, however I can't figure it out. From what I understand I am supposed to export the data into Excel, which I don't know much about, and make a table or something. Could some one please explain this to me. It appears that the one VE pid is reading the same info as what LS1 Edit uses in its VE tables. Any help is appreciated. Thanks in advance.

Steve Bryant
March 16th, 2005, 03:12 AM
PHP,
Take a look at this thread http://efilive.com/forum/viewtopic.php?p=8941#8941 . Then if you send me your e-mail address in a PM I'll send you an excel spread sheet to help you set up VE easily.

I won't be back home for about ten hours, but you can at least read the thread. It will all make sense in time.

Steve

PHP INC.
March 17th, 2005, 05:07 AM
I will definitely check that out. Thanks. I will send you a pm with my email address. I was going off of this post http://www.efilive.com/forum/viewtopic.php?t=184 and thought you didn't have to disconnect the maf. Thanks again.