PDA

View Full Version : This is starting to look scary


ViolatorTA
July 31st, 2006, 07:10 AM
After about 4 good logs. Me thinks me needs some smoothing.:help2:

http://img120.imageshack.us/img120/3379/picture11dn5.th.png (http://img120.imageshack.us/my.php?image=picture11dn5.png)

http://img271.imageshack.us/img271/7011/picture12kg3.th.png (http://img271.imageshack.us/my.php?image=picture12kg3.png)

click on image for larger veiw
SSpdDmon
July 31st, 2006, 08:35 AM
Are you getting similar results after each log in your BEN map? If so, are you sure your MAF is disabled?
ViolatorTA
July 31st, 2006, 10:30 AM
MAF is didabled. Could it be the cam?
joecar
July 31st, 2006, 11:24 AM
Post pic of BEN map.
ViolatorTA
July 31st, 2006, 12:01 PM
Post pic of BEN map.

Joe,

Last 2 BEN maps are in the other thread with Garry. Primary and secondary BEN maps, commanded AFR and LC-1 actual AFR listed in 2 seperate posts.

On my way to do another logs with latest changes.


Shawn
ringram
July 31st, 2006, 08:33 PM
Hit it with the smooth hammer. Also you will likely find that you arnt hitting all cells so some of the peaks will be from there. Just hit smooth once.
As Joe says if your BEN's are 1 or close to it, then all is well.
98SS2836
July 31st, 2006, 11:37 PM
that looks a little like mine. I run is CLSD now -2 trims accross the board I was little lower than that but added 1% fuel to the whole table to be safe with the new shit gas.
ViolatorTA
August 1st, 2006, 03:35 AM
Hit it with the smooth hammer. Also you will likely find that you arnt hitting all cells so some of the peaks will be from there. Just hit smooth once.
As Joe says if your BEN's are 1 or close to it, then all is well.

Ok, smoothing is what scares me. Smooth the entire table? Which smoothing tool? I have to make another log run since I found out that my ECT connector vibrated off about halfway through the last log run and I overlooked it before making changes. The SES needs 2 start cycles before turning on and it came on when I went to log some more. That sent me back to check the entire log to see where it came off. About 25 mins into a 40min run.:bash: Make sure the plug clicks all the way on when you do H/C...lol
joecar
August 1st, 2006, 03:42 AM
Joe,

Last 2 BEN maps are in the other thread with Garry. Primary and secondary BEN maps, commanded AFR and LC-1 actual AFR listed in 2 seperate posts.

On my way to do another logs with latest changes.


ShawnAh, ok, I just connected... :cheers: