AEM UEGO 30-0300 Connect Via Serial

[dlatsch]

Hey all. I'm new to EFILive's V3. I am trying to connect my 30-0300 AEM UEGO wideband using a serial connection to my V3, but I just keep coming up empty. I've verified my gauge pops up as a com port on my PC, but I can't get any reading off of it. I really believe I set everything up correctly in the configuration settings on the V3 and that I'm referencing the correct PID. Has anyone else tried hooking up this specific wideband yet?

[nonnieselman]

I gave up on the AEM on a truck a couple weeks ago. I never could get it to work.
Hooked up a LC2 Innovate and worked perfectly.

[dlatsch]

I gave up on the AEM on a truck a couple weeks ago. I never could get it to work.
Hooked up a LC2 Innovate and worked perfectly.

I sort of tried the same thing. I have a different project with an LC2. With that vehicle running, I tried to read the LC2 via serial but I ended up being unsuccessful there too. I didn't spend any time checking my logworks settings for the LC2 though. I reached out to support from EFILIVE with very little help. So for now, I abandoned the serial connection and routed the analog signal back to the PCM (0411) using the EGRS pin 55 (pin 41 GND) location and I was able to get the data to EFILIVE that way after enabling EGR. Its a lot of messing around, which is pretty disappointing.

[nonnieselman]

Ill have to get on my other computer and get my PID list posted to see if that would help you.

[dlatsch]

I never did get this figured out. I ended up hooking up to my WB by EGR input. That seemed to work well but I still find it odd the serial port never worked out.

[nonnieselman]

I just realized you were using a V3.
Ive never used one so not sure how that works.
I mainly use LC2 with serial into my V2.