PDA

View Full Version : COS #5 what am i doing wrong!!!



AGRO
August 12th, 2006, 09:48 PM
well i had a crack at the cos 5 on the 8tb equipped car, full reflash and all that, went to fire it up, she starts idles for one second then shuts down, it will not rev with throttle help, nothing, the log file shows the injector ms hit zero when it starts, what the hell am i doing wrong????

(A0003)= enable :D
(A0004)= 105 kpa
(A0005)= 8000rpm
(A0006)= 101 %

please help, fyi the map ve still exists.

cheers

GMPX
August 12th, 2006, 10:02 PM
What you have there is, the TPS VE table will be used when the TPS is below 101 %, below 8000rpm and below 105 kpa.
Basically always, I would assume you have some numbers in the TPS VE Table?

Cheers,
Ross

AGRO
August 12th, 2006, 10:07 PM
well yeah, i want to strictly use the tps for this motor, the cam idles around 89kpa, i do have numbers in both ve's too, its got me, really got me.

ringram
August 12th, 2006, 10:55 PM
Id disable the tps table and get it working with a known good tune first. I assume you had this running on something else before?
If so you can use the good tune to check/verify your tps table.
How did you create your tps table?
Maybe enable it a little at a time with loads of logging.

Problem when a car doesnt run much at all is that you dont get any logs to see what the problem is. So best to start with something that works and go from there.

Tordne
August 13th, 2006, 08:36 AM
This is how I migrated to TPS VE (just as a test - but it worked great) http://forum.efilive.com/showpost.php?p=27713&postcount=130

AGRO
August 13th, 2006, 11:41 PM
whoops! i found the bugger of a problem, i set the mar frequency to not reported:nixweiss: , changed it over and voila!! we have a tps ve working,
this tps ve is the best thing since sliced bread.

BowlingSS
August 14th, 2006, 02:54 AM
whoops! i found the bugger of a problem, i set the mar frequency to not reported:nixweiss: , changed it over and voila!! we have a tps ve working,
this tps ve is the best thing since sliced bread.

I am having similiar problems. What is the mar frequency?

Bill

wait4me
August 14th, 2006, 03:35 AM
mass air flow it must have been a mis print

BowlingSS
August 14th, 2006, 04:12 AM
mass air flow it must have been a mis print

I do not have one of them....Mine is hanging on the wall...:cheers:

Bill

AGRO
September 2nd, 2006, 09:34 AM
the maf has been tucked away for a while now ;) the maf performance (p0101) was set to not reported.

ringram
September 2nd, 2006, 11:13 AM
I sold mine months ago...