Cm 2100

[Dieselkid01]

hi everyone, I have a cm2100 for my 6.7 build i want to run standalone. I have the firepunk standalone harness on c1 and c2. the ecm I have I was told was good, but I believe the SKIM is preventing me from connecting to it with my v2. I keep getting vehicle not detected. is there a way for me to force a base file on it? I already have one from the tune library that I turned off all the security on. thanks!

[Jim P]

ECMs don’t need to be connected to a vehicle to flash with EFILive, I flash them on a bench all the time, so wouldn’t be skim. Check, power, ground and communication wires.

[Dieselkid01]

I will check again but when I went through the pin out all the pins requiring power or ground were getting them.

[Dieselkid01]

all are getting power and ground, when I try to flash the BootRSA I get the ignition is not switched. pin 45 on C2 is start/run and has 12v to it

[Jim P]

ecm isn't powering up

[Dieselkid01]

Is this a common issue with them that can be repaired ? Or possibly I’m missing something that still needs to be hooked up