cm2200 brick

[KhYurii]

cm2200 brick
Dodge ram 6.7 2011

Got it loaded by OBD.
Silent on the channel and on the table (There are no idents.
I loaded RCA into Boot from the CM90032.03 block, the block got in touch, but Calterm writes FlashFailed when the firmware is up to 100%.
What should I do? Help please


17:39:04:349 PDLWrapper.PDLException: impl\dlalg\GTISDownload\GTISDownload.cpp, L:643 E:8 - Run Engine Using Default Code and Data Command Failure: [CMDB=21 - Unknown] [PDL Err Code = 8 ]
в PDLWrapper.PDLDownload.executeReflash(String calFileFullPath, PDLSaveRestoreHandlerEvent saveRestoreHandlerEvent)
в PDLDownloadLib.CalDownload.BwJ1yHwwBiy7pavfJv2(Obj ect , Object , Object )
в PDLDownloadLib.CalDownload.StartDownload()
[PDL Err Code = PDL_ERR_POSTPROCESSING_FAILED]
[ExceptionTypeCode = PCL_ERR_NEG_ECU_RESPONSE_EXCEPTION]

24709

[MrGrunzz]

Hey there! Make sure you are using the under the hood plug for correct communication, standart OBD port will not work with Calterm or Insite at times. Reading through obd on cummins engines is not recomended, always bench the ecm. Let me know if i can assist you, I'm new to efi live, yet i have experience with calterm, intiste and many other heavy dutty stuff.

[KhYurii]

the block is on the table. before flashing the bootloader, it did not communicate at all (the Culter does not want to flash it, the error message was thrown from above. What to do?

[MrGrunzz]

What is your ESN? You might need to flash a 100% stock file then once flashed, read it with efilive and work with that new file.

[KhYurii]

in the photo above, I can't flash it(

[MrGrunzz]

Send me a pm, I will try to assist you

[KhYurii]

I don't understand how to do it here

[MrGrunzz]

Send me a message through skype, we will sort how to communicate that way.

live:.cid.6db66634063d7482