Diesel2014
January 16th, 2026, 04:56 AM
Does anyone know how the 5 position switch gets wired into the obd2 port on a cm2350? Is it just wired to the can? Id like to make my own harness to wire it in as I have a monitor in the obd port now. I know there are pass through cables but im trying to avoid those. I will have the switch set up to be unplugged during flashing as well. Ive all ready made a harness for the engine so I cannot wire it into the crank case vent, as those wires are gone.
Thank you.
Thank you.