Changing Units in Tables

[VetPet]

I was setting up to do some AutoVE tuning and was wondering how you go about changing the units the tables are in for PE and Commanded Fuel from EQ to AFR. The top of the tool bar under Edit shows 'Configure Display Units' but when I open it I can't make any changes to the table I want. I'd like to change the precision from 1 to 2 decimals as well.

Thanks,

:cheers:

[joecar]

In the tune tool, close your tune file, and go Edit->Configure Display Units and then look here (last item): showpost.php?p=27274&postcount=1 (http://forum.efilive.com/showpost.php?p=27274&postcount=1)

[joecar]

I was setting up to do some AutoVE tuning and was wondering how you go about changing the units the tables are in for PE and Commanded Fuel from EQ to AFR. The top of the tool bar under Edit shows 'Configure Display Units' but when I open it I can't make any changes to the table I want. I'd like to change the precision from 1 to 2 decimals as well.

Thanks,

:cheers:
Do you mean that you can't see the table you want to change...?
Which table is it...?

Oh, if it's PE and OLFA, go Edit->Properties and in the middle of the first tab is AFR/EQ/Lambda.

Joe

[TAQuickness]

For decimal precision, (in the tune tool)there is a tool bar icon with +0.000 and -0.000 (or very similar to that) in the lower right hand section of the tool bar. Click'm and it will change the decimal resolution.

[SSpdDmon]

Search is healthy too...

http://forum.efilive.com/showthread.php?t=2722&highlight=bullseye

[VetPet]

Hey Guys, thanks for the help. Hoping to get my BEN's dialed in this weekend and complete the autoVE tuning.

:cheers: