log file does not highlight cells in tuning tool

[AGRO]

Hi all, before updating to the latest software, the scan tool *use*to correspond to the cell that i had highlighted, example: say i was to highlight the chart at 1456rpm map 81, then switch over to the tuning tool and open the ve table, map 80 @ 1600rpm would be highlighted, unfortunately this doesnt happen anymore:frown: its not such a big deal for me but it makes life a lot easier.

any help is much apreciated.

Agro.

[TAQuickness]

from the tune tool

Edit -> Properties
Click Scanner Tab
Check "Highlight Scan Tool selection in Tune Tool maps"

You may need to close and re-open the tune tool when you're done

[AGRO]

thanks for that, unfortunately its still not working correctly, when at map 35 on scanner, the tuner reads map 15, map 100 reads map 30 on the tuner, the rpm is ok, any other sugestions?

[Black02SS]

In the PIDS tab of the Scan tool, right click and select "Metric". See if that helps.

[TAQuickness]

the units between the scan and tune tool have to match

[AGRO]

In the PIDS tab of the Scan tool, right click and select "Metric". See if that helps.

That fixed it :notacrook: bloody ripper. thanks for that

[TAQuickness]

Good deal. Welcome to the forum Agro

[Black02SS]

Glad to see it all worked out for you. :)

[joecar]

AGRO,

Additionally, you may also want to try "runway highlighting"...

the enable checkbox for it is located in same place as post #2 by TAQuickness.