PDA

View Full Version : Bug in AutoVE tutorial?



Garry
September 20th, 2006, 11:12 PM
Page 14:



9. Open calibration {B5913} "Spark High-Octane Table" Select all cells by clicking in the extreme top-left, grey cell. Right click on any cell and select Copy (Ctrl+C) Open calibration {B5914} "Spark Low-Octane Table" Right click in the top left cell and select Paste->Paste (Ctrl+V)

If you upgrade your PCM to EFILive’s Speed Density custom operating system, step 7 is not required. EFILive’s Speed Density operating system restored dual spark map and full adaptive spark control when running MAF-less.

I figure this is supposed to be "step 9"?

TAQuickness
September 21st, 2006, 01:58 AM
Noted. Will update in the very near future. Thanks Garry.

Garry
September 22nd, 2006, 09:56 PM
Hm ... just looking at it again, what about table B3605, commanded fuel in open loop -- doesn't seem to be available w/ OS5 .. !?

TAQuickness
September 22nd, 2006, 10:15 PM
Yup. I've been slacking lately. But us OS5 guys are aware of the change ;)