Garry
September 21st, 2006, 12:12 AM
Page 14:
9. Open calibration {B5913} "Spark High-Octane Table" Select all cells by clicking in the extreme top-left, grey cell. Right click on any cell and select Copy (Ctrl+C) Open calibration {B5914} "Spark Low-Octane Table" Right click in the top left cell and select Paste->Paste (Ctrl+V)
If you upgrade your PCM to EFILive’s Speed Density custom operating system, step 7 is not required. EFILive’s Speed Density operating system restored dual spark map and full adaptive spark control when running MAF-less.
I figure this is supposed to be "step 9"?
9. Open calibration {B5913} "Spark High-Octane Table" Select all cells by clicking in the extreme top-left, grey cell. Right click on any cell and select Copy (Ctrl+C) Open calibration {B5914} "Spark Low-Octane Table" Right click in the top left cell and select Paste->Paste (Ctrl+V)
If you upgrade your PCM to EFILive’s Speed Density custom operating system, step 7 is not required. EFILive’s Speed Density operating system restored dual spark map and full adaptive spark control when running MAF-less.
I figure this is supposed to be "step 9"?