PDA

View Full Version : LC-1 work with flashscan


87gmc
April 7th, 2005, 07:16 AM
Going to order the LC-1 from the makers of LM-1. Will the LC-1 work with flashscan?
Dirk Diggler
April 7th, 2005, 07:20 AM
As long as you have an analogue output Flashscan will work with it
Blacky
April 7th, 2005, 09:46 AM
As Dirk said, you just need an analog voltage output.

On this web page:
http://www.motorsportsinnovations.com/wide_band_o2.htm
The LM-1 is shown with the following feature:
"0-5 volt output for any Data Acquisition system"

If the LC-1 has that same feature then it will work with FlashScan.

Regards
Paul
87gmc
April 7th, 2005, 03:28 PM
Like the LM-1, the LC-1 has 2 analog outputs that you can freely program. Look at the LM-1 manual for details. The analog out programming of the LC-1 is identical. The only difference is that the LC-1 has separate grounds for heater and system. This way the ground offset issues of the LM-1 analog outs are minimized or eliminated. Also the output resolution of the LC-1 is 12 bits (~1.2mV) while the LM-1's analog outs are 10 bit (~5 mV).
The analog outs are completely independent of the serial stream that feeds the XD-1 or (future) LogWorks.

Regards,
Klaus

Found this on there website
BowlingSS
April 18th, 2005, 04:32 AM
I just ordered a LC-1. VE table here I come...

Bill
mistermike
April 18th, 2005, 11:06 PM
Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.
BowlingSS
April 19th, 2005, 07:55 AM
Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.

Call Chris At:
APEngineering
586-954-3181

Bill
mistermike
April 24th, 2005, 02:42 AM
Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.

Call Chris At:
APEngineering
586-954-3181

BillThanks, Bill!