PDA

View Full Version : Ls2 Scantool Not Tracking


linden
November 27th, 2006, 05:45 AM
can you guys help
i have upgraded my v2 to the latest soft and firm ware, know the scan tool will not track the timing map.i have checked all the pids and they are supported but it will only track the first or last collum of the spark tabel. can you give me any help. also the comarnded AFR is not correct on the dash.
PS all the pids in the tune section are marked as not supported is this correct or not.:Eyecrazy:
joecar
November 27th, 2006, 08:20 AM
Linden,

Make sure the pids shown on the tune map axis's are selected in the scan tool and that they are valid; take a new log with these.
Dirk Diggler
November 27th, 2006, 09:49 AM
Also make sure the units are right in the scanner.
ringram
November 29th, 2006, 10:52 PM
I think the issue was the SD pid wasnt working. Reconnect MAF and used maf airflow pid and it worked. Not sure why SD pid wasnt working yet.
Blacky
November 29th, 2006, 11:15 PM
the comarnded AFR is not correct on the dash.
PS all the pids in the tune section are marked as not supported is this correct or not.:Eyecrazy:

Use GM.AFR_B on the LS2

The PIDs will be marked as supported once you connect to a vehicle and run the Validate PIDS option.

Make sure you are using the latest software, here:
http://forum.efilive.com/showthread.php?t=3906
It contains some fixes for the PID validation routines.

Regards
Paul