billyjo
December 18th, 2006, 04:51 PM
I've been trying to get my VE and Boost VE in tune for the last week and I'm not having any luck. I'm sure I must not have something set up correctly but I've been through the Auto Ve tutorial several times double checking myself but I can't fine the problem.:help2:
I'm using COS 0202003 with a 2 bar map sensor and V1.
So a few things I've noticed but don't know what to make of them:
1. I don't have a (B3605)"commanded fuel when in open loop" does this matter?
2. The more logs that I record then "paste and multiply with labels" the leaner my AFR gets :Eyecrazy:
3. If I go to "dashboard B" and highlight a section (I am looking @ AFR) then go to the boost or primary VE the Kpa doesn't correspond, only the RPM does:nixweiss:
Is all of this normal? I be in all honestly I've made 20 different logs and I don't think I'm any closer than when I started.
Please help,
Bill
I'm using COS 0202003 with a 2 bar map sensor and V1.
So a few things I've noticed but don't know what to make of them:
1. I don't have a (B3605)"commanded fuel when in open loop" does this matter?
2. The more logs that I record then "paste and multiply with labels" the leaner my AFR gets :Eyecrazy:
3. If I go to "dashboard B" and highlight a section (I am looking @ AFR) then go to the boost or primary VE the Kpa doesn't correspond, only the RPM does:nixweiss:
Is all of this normal? I be in all honestly I've made 20 different logs and I don't think I'm any closer than when I started.
Please help,
Bill