PDA

View Full Version : Copy and Paste



Lextech
January 1st, 2007, 03:55 PM
Today I finally got up the nerve to install a COS. I am not sure how to Copy and Paste my initial tune parameters into the new 2bar tune. Where should the cursor be when I copy from and paste into the new tune ?

Tordne
January 1st, 2007, 04:37 PM
When changing to the COS are you also changing the OS year (i.e. from say a 2000 to 2002)? If the stock and COS are related you can just follow the COS tutorial and cal flash in your current parameters.

As for where the cursor should be the obvious answer is on the data which you wish to copy. So ordinarily you would select one or more cells and copy them, then select those same cells in the other tune and paste.

You can also select the required cells and "copy with labels". In this case when "pasting with labels" into the other tune it doesn't matter what cell is selected as the label data takes car of that ;)

You can select an entire row or column by clicking on the header for that row/column. You can also select an entire table by clicking in the top left corner where the x and y axis meet, or press the CTRL+A shortcut key combination.

Hope that helps,

Lextech
January 2nd, 2007, 03:26 AM
Thank You, My biggest problem when it comes to computer stuff is that I AM CHICKEN. I need to get over that and just do it.

Tordne
January 2nd, 2007, 05:35 AM
There is always the Undo function (CTRL+Z shortcut) ;)

Lextech
January 2nd, 2007, 04:34 PM
Entire Table is what I was looking for----Thank You