View Full Version : How do you see...
SSpdDmon
January 8th, 2007, 05:40 AM
...other .pids (like MAP kPa) while using the bi-di controls? I thought I read somewhere that you can still see what's going on when you're playing with the controls. Can you?
TAQuickness
January 8th, 2007, 06:39 AM
Do you mean by:
Connect the scan tool
Select PID's
Open the control pannel
Start logging in the back ground
That's usually what I do, then switch to a chart view so I can see the effects.
Tordne
January 8th, 2007, 06:59 AM
The key is to NOT start recording before opening the Control Panel. When using the Bi-Di Control the frame rate drops from 10fps to 5fps, to allow the extra bandwidth required on the bus for the Bi-Di operation.
If you have already started logging at 10fps then the Bi-Di Controls can't work.
SSpdDmon
January 8th, 2007, 07:19 AM
The key is to NOT start recording before opening the Control Panel. When using the Bi-Di Control the frame rate drops from 10fps to 5fps, to allow the extra bandwidth required on the bus for the Bi-Di operation.
If you have already started logging at 10fps then the Bi-Di Controls can't work.
Ah ha! This sounds like the issue I was having. Thanks guys! :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.