PDA

View Full Version : PE mode



turbo lcc
January 28th, 2007, 05:17 PM
Is there a rule of thumb for entering PE mode in B3616 - for best performance/fuelmilage?

Also can you modify this table and leave the others in this area stock assuming the PE delay is set to 0.

SSpdDmon
January 29th, 2007, 02:11 AM
Don't have the other laptop, but if this is the PE TP% Enable table...I like to drop it a little (~10%) from stock - epsecially on modded cars. It can hurt fuel economy a little. But, it can also make moderate throttle feel a little better IMO. Mainly, my goal when tuning others' cars is to keep things a little on the safe side. A little more fuel at a moderate engine load can't hurt...

ringram
January 29th, 2007, 02:34 AM
IMHO raise MAP enable to 80kpa so you dont go into PE when not underload.
Why do you want PE when reversing up hill etc?
So PE is only enabled when MAP is over 80kpa.