calibrating ad inputs

[mr.prick]

can i calibrate the ad1-ad4 inputs with the lc1 or do i need another device?

[Tordne]

I believe with the LC-1 software you can have it command set voltages and can therefore be used to calibrate the FlashScan V2. I've seen threads on here with people doing exactly that.

[Garry]

Also, given that no two devices are exactly equal, it might even be the best idea to calibrate it based in the LC1 - that way, when the LC1 thinks it delivers - say - 2V, and you adjust V2 to understand the voltage it gets as 2V, you should be all set ...

[mr.prick]

i found that i had to reboot the lc1 after programing the analog outs
for the values to be set and show correctly on the v2.
i used a separate power source so i did not have to turn off the v2 while rebooting the lc1.

[joecar]

i found that i had to reboot the lc1 after programing the analog outs
for the values to be set and show correctly on the v2.
i used a separate power source so i did not have to turn off the v2 while rebooting the lc1.That's correct.