Need unfo on upgrade from 6.4.1

[Joslyn]

I have been gone for a while with a busted laptop but it is "working" again.
I have an AT1 connector and 6.4.1.

Can I upgrade still to the latest with this connector?
Is the upgrade free?
Will my weak little 650 MHz processor still get the job done?

I barely figured out what I had in 6.4.1 before I stepped away. Now I will have to relearn all of what little I knew but first I need to know if I can upgrade.

Thank you.

[joecar]

Joslyn,

Welcome to the forum... :cheers:

Version 7.3.4 software should run on the AutoTap AT1 cable...
See post #6 of this thread: showthread.php?t=4442 (http://forum.efilive.com/showthread.php?t=4442)

As for running on your 650 MHz PC, I believe the Scan Tool should be fine, but I pm'd Paul (Blacky) for a better answer.

Also, there have been various new developments which you may or may not be aware of...
see the updated website: http://www.efilive.com
and see here also: http://www.efilive.com/download.aspx

Which vehicle do you have...?

Cheers
Joe
:cheers:

[Blacky]

The official minimum specification is 500MHz but we recommend 800MHz or more.

You may need to optimize some settings in the Scan Tool software to obtain the best performance. The optimization settings and techniques are decribed in Appendix-G of the Scan Tool User Manual.

Regards
Paul

[Blacky]

The upgrade from V6 Pro to V7 Scan Only is free.
If you have V6 Std then the upgrade is USD $100, which is the price difference between Std and Pro.

Send your AutoTap serial number and EFILive V6 Pro registration code to me at paul@efilive.com and I will send you back your free V7 upgrade registration.

Regards
Paul

[Joslyn]

Sent you an e mail hope you get it. I think my original got spammed.

Thanks, Mike