PDA

View Full Version : 2-3 not shifting



ASSAMI
February 27th, 2007, 11:02 PM
o.k.,

2002 Holden Camador ( Lumina ) 5.7L

All shifting points are fine except the 2nd to 3rd :(
It doesn't shift tell it hits the Rev Limiter !!!

I even put the Rev Limiter at 7200 and the shifting point at 6400. Yet it doesn't shift with WOT and it hits 7200.
I have to take my foot from the pedal so it will shift and then repress.

I have also changed the shifting solenoid thinking it was not good but no luck :(

Biggsy
February 27th, 2007, 11:15 PM
Check where your 3-2 downshift is set at.
Post your tune so people can look at it.

ASSAMI
February 27th, 2007, 11:38 PM
Sorry and thanks:)

joecar
February 28th, 2007, 05:03 AM
Assami,

Reduce the 2-3 WOT MPH (and also set 3-2 WOT MPH to be below that) to say 50 MPH, and see if you get the shift;

if yes, then increment to 55 and test again (and continue to 60, 65);
if no, then reduce the 2-3 WOT RPM to 5000 and test again;

At all times: keep the 3-2 WOT MPH at least 5 MPH below the 2-3 WOT MPH.

I would also suggest setting all the Kickdown Throttle settings to 100%.

billiardcue
March 6th, 2007, 11:12 AM
Assami,

Reduce the 2-3 WOT MPH (and also set 3-2 WOT MPH to be below that) to say 50 MPH, and see if you get the shift;

if yes, then increment to 55 and test again (and continue to 60, 65);
if no, then reduce the 2-3 WOT RPM to 5000 and test again;

At all times: keep the 3-2 WOT MPH at least 5 MPH below the 2-3 WOT MPH.

I would also suggest setting all the Kickdown Throttle settings to 100%.
Is this also true for the 1-2 and 2-1 shift settings?

joecar
March 6th, 2007, 11:43 AM
Is this also true for the 1-2 and 2-1 shift settings?Yes, same method applies for 1-2 and 2-1.