pkincy
April 7th, 2007, 09:07 AM
Is there a general thread with directions for dummies on hooking up a wideband to the V2?
I have read most everything available and do have my Vout hooked into the + terminal on one of the analog inputs and the corresponding ground from the wideband (TE) hooked into the negative terminal.
I have set up my PIDS, but am getting an invalid PID reading and no output upon logging from the Ben (TE) and AFR (TE) PIDS.
Wouldn't the V2 validate the PIDs automatically or do I have to do something strange?
Perry
Let me edit this and withdraw the question. I see some threads on this subject under Scanning General. Also I need to get a better Vout signal from my DIY Tech Edge.
I have read most everything available and do have my Vout hooked into the + terminal on one of the analog inputs and the corresponding ground from the wideband (TE) hooked into the negative terminal.
I have set up my PIDS, but am getting an invalid PID reading and no output upon logging from the Ben (TE) and AFR (TE) PIDS.
Wouldn't the V2 validate the PIDs automatically or do I have to do something strange?
Perry
Let me edit this and withdraw the question. I see some threads on this subject under Scanning General. Also I need to get a better Vout signal from my DIY Tech Edge.