PDA

View Full Version : MASS code with BOOST



ASSAMI
April 23rd, 2007, 09:00 PM
Hello guys ,

I'm having a problem with this avalanche . It's a stock motor with nothing on it except STS turbo kit . it is making 334WHP ON 7PSI with 5.3L engine in it .

Every about 100 miles the cars power goes sharply down and it starts detonating . the MIL comes on with a code for the MASS sensor.
PO101


Any clue how can I get this code off of my back .

Cheers

dc_justin
April 24th, 2007, 01:44 AM
Hello guys ,


I'm having a problem with this avalanche . It's a stock motor with nothing on it except STS turbo kit . it is making 334WHP ON 7PSI with 5.3L engine in it .

Every about 100 miles the cars power goes sharply down and it starts detonating . the MIL comes on with a code for the MASS sensor.
PO101


Any clue how can I get this code off of my back .

Cheers

Hi Assami,

Check out the MAF Rationality Table. This table defines the allowable "discrepancy" between the MAF and VE table. Boosted 1 bar applications need this to be increased quite a bit.

Justin

ASSAMI
April 24th, 2007, 06:41 AM
Hi Assami,

Check out the MAF Rationality Table. This table defines the allowable "discrepancy" between the MAF and VE table. Boosted 1 bar applications need this to be increased quite a bit.

Justin

quite a bit ??? who mush ?:master:

dc_justin
April 24th, 2007, 06:50 AM
quite a bit ??? who mush ?:master:

I would multiply that table by a factor of 4 to 5 to be on the very safe side.

ASSAMI
April 25th, 2007, 08:06 PM
:nixweiss: SAME THING ...!!!

AM I DOING SOMETHING WRONG HER ??

PLEASE PEOPLE :frown:

dc_justin
April 26th, 2007, 04:12 AM
:nixweiss: SAME THING ...!!!

AM I DOING SOMETHING WRONG HER ??

PLEASE PEOPLE :frown:

Mind posting up the tune or emailing it to me?