MAP question

[DaddySS]

Looking at main ve table - it says "Map kpa", and my scanner chart is in map kpa but they are not in synch, the ve table has rpm correct but map at 30?

[SSpdDmon]

Try going to the F8 tab and right clicking on the MAP pid to make sure metric is selected. I think that can cause some sync problems between the scanner and the tuning software.

[DaddySS]

Try going to the F8 tab and right clicking on the MAP pid to make sure metric is selected. I think that can cause some sync problems between the scanner and the tuning software.

That was it!!!! Once again - thanks!!!:)