PDA

View Full Version : MAP question



DaddySS
May 15th, 2007, 09:04 AM
Looking at main ve table - it says "Map kpa", and my scanner chart is in map kpa but they are not in synch, the ve table has rpm correct but map at 30?

SSpdDmon
May 15th, 2007, 10:54 AM
Try going to the F8 tab and right clicking on the MAP pid to make sure metric is selected. I think that can cause some sync problems between the scanner and the tuning software.

DaddySS
May 15th, 2007, 12:28 PM
Try going to the F8 tab and right clicking on the MAP pid to make sure metric is selected. I think that can cause some sync problems between the scanner and the tuning software.

That was it!!!! Once again - thanks!!!:)