dbaxter_ss
May 16th, 2005, 07:30 AM
Not sure what is up, every time I scan my SS it shows during the "Retrieve all test results", System Readiness Tests(EPA) INCOMPLETE, then Oxygen sensor Heater - Not Ready.
I went to the testing center and figured since NC lets you pass with 1 not ready ( or thats what I was told ) I would try and if I failed at least this is an easy one to fix and just get more driving cycles in.
Well I went through the testing and the NC inspection station showed all the tests passed. Everything. No not ready's, no failed, just all passed.
One other thing is that prior to going there 2 times, once in my works parking deck I did the - Start the car, let it idle with the a/c on full blast and rear window defogger one, sterio ( as much load as possible ) for at .east 2 1/2 minutes ( efi showed this same - not ready ). I did this again after leaving the gym getting ready to goto the station and it once again showed - not ready.
Something not being read right, they were pretty picky going over every little possible thing so I am pretty sure their OBDII was working correctly?
I went to the testing center and figured since NC lets you pass with 1 not ready ( or thats what I was told ) I would try and if I failed at least this is an easy one to fix and just get more driving cycles in.
Well I went through the testing and the NC inspection station showed all the tests passed. Everything. No not ready's, no failed, just all passed.
One other thing is that prior to going there 2 times, once in my works parking deck I did the - Start the car, let it idle with the a/c on full blast and rear window defogger one, sterio ( as much load as possible ) for at .east 2 1/2 minutes ( efi showed this same - not ready ). I did this again after leaving the gym getting ready to goto the station and it once again showed - not ready.
Something not being read right, they were pretty picky going over every little possible thing so I am pretty sure their OBDII was working correctly?