PDA

View Full Version : Have to flash twice?



zapp168
June 4th, 2007, 11:42 PM
I did the 98 to 99+ swap!
The car runs fine, then I flash it, it starts up, runs ok for 15 seconds, then starts running horrible! I let it run (once for 15 min) but mostly it idles, but if I touch the gas it dies. I re-flash with the same flash, at 15 seconds it starts to stumble, then clears up, and runs fine after? Any ideas?

zapp168
June 8th, 2007, 08:56 AM
I Figured this out, but did not have time to post. The MAP was plugged in the wrong spot. For some reason the first time I flashed the AFR went nuts, the seconfd time it must have gone into limp mode and disregarded.

Maggie
June 8th, 2007, 09:33 AM
Good to hear you got it worked out.
:cheers: