PDA

View Full Version : o2's moved.....



98SS2836
June 21st, 2007, 12:59 PM
When you move your o2 sensors down the exhaust it will cause them no to heat properly. Does this cause the switching point to be changed what table can correct this. I know in SCT mustangs there is a table you just decrease 15% to correct so there will be no ses lights and I believe to switch properly.

shallow bay
June 21st, 2007, 03:35 PM
{B4105} O2 Switch point

98SS2836
June 21st, 2007, 10:21 PM
{B4105} O2 Switch point

I started fooling with that I believe i would want to reduce that table correct?

The Alchemist
July 10th, 2007, 08:28 AM
I've experimented with the switchpoint settings and found that about 400mv seems to bring down the logged AFR from 14.4:1 to 14.6:1 but thats measureing at the tail pipe with a long tube AFR holder. May be slightly different further up the line. This is a very "fine" change though.

Zfreak
August 28th, 2007, 12:08 AM
I'm starting to look into this table in order to resolve some switching errors (CEL) that I'm getting. The 02's don't oscillate as high and low as they should when under light throttle. They jump right to .880-.900 at WOT and right to .005 when decelerating (dfco) so I know the range and response is fine. I noticed that my stock tune was all over the place on the 02 table...I changed it to all 450 for now and I'll see how it goes from there.