PDA

View Full Version : Can't Save



dbaxter_ss
May 28th, 2005, 09:02 AM
I have checked everywhere, but I can't save. I can log without any problems but when I stop the logging it no longer auto prompts to save, and even if I try to save afterwards it wont prompt for a file name to save.

I uninstalled twice now, made sure nothing was left in any directories but still no luck. Any ideas?

Below is my logging properties, should I turn off autologging, is there anything in the registry that could have been set. Save and Save as works in all my other programs.

I am sure its something stupid I turned on but just can't seem to find it

http://www.purplegto.com/files/savelogging.png

Scoota
May 28th, 2005, 11:33 AM
That’s a strange one Derrick,
The settings look to be ok.
'Have you attempted reinstall and repair after installing the software'. It would also be interesting to know what version you are installing. Other than that, this might be one for paul.

Cheers, Scotty,

Blacky
May 28th, 2005, 11:45 AM
Check in the [Folders] tab page that the "logged data" folder is a valid folder. If it does not exist or contains invalid characters (such as * ? etc) then you may not be able to save any log files.
Paul

dbaxter_ss
May 28th, 2005, 01:22 PM
Well I uninstalled again, and this time I also wiped all EFI stuff out of the registry.

The folders directory was set to the <vin> but also was creating a new vin directory when I opened a new session of scanner. I dont think the tree depth went to deep but its possible.

I just changed the folder to logged data and will check it out tomorrow. Coca Cola 600 is here in Charlotte this weekend so I am pretty much trapped at home.

This is a weird one, I am sure its something I did and I will figure it out.

http://www.purplegto.com/files/folder.png