View Full Version : Bootloader rejected and no response from truck
abkimble
July 13th, 2007, 12:07 PM
Hello all
During a tune write, my power cord to my laptop was removed by a pilgrim. Now I get bootloader rejected with a possible locked ecm. Any suggestions?
Thanks
floriduramax1
July 13th, 2007, 12:27 PM
Disconnect battery for about 10-20 minutes.
abkimble
July 13th, 2007, 01:12 PM
Disconnect battery for about 10-20 minutes.
thanks for the reply
i tried but no luck.
thanks again
Chevy366
July 13th, 2007, 02:03 PM
I had a battery crap out on me during a flash , did as the other guy said , disconnected the battery and the V1 or V2 and after reconnecting the battery and V1 or V2 did full re-flash with stock .tun .
From what I remember reading was it depended when the interruption happened , what segment of the flash it was in . I think the first 4 seconds is the worst or when the red light is lit on the stop light indicator , yellow or green can be recovered from .
wait4me
July 13th, 2007, 04:47 PM
$FFFF
Put that in as the key and see if that works. If not, you can send me the pcm and i will take a look at it.
abkimble
July 14th, 2007, 06:50 PM
$FFFF
Put that in as the key and see if that works. If not, you can send me the pcm and i will take a look at it.
Hello and thanks for the suggestion.
I tried this key with no luck.
I'll look you up for possible mail in repair.
Thanks again.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.