CGTMS
August 25th, 2007, 08:09 AM
Hello all,
I am debugging a Code P0327 on a LS6 Lingenfelter motor. I am assuming that PID ESC1DNL is for the front KS and used with P0327....
Data logging shows very low counts on sensor 1 "Front?" (8 to 10 range) and higher counts on sensor 2 "Rear?" (120 to 180 range). This under light loads around 35 MPH in 4th gear.
It would seem based on the data that the code is caused by a faulty front sensor because the counts are so low. I swapped connections between the sensors and the "low counts" reading moved to sensor 2. This would tell me that it is not a faulty ECM or wiring from the sensor to the ECM.
Sound about right....I want to be sure before I have to pull the intake and change the sensor.
Thanks.
I am debugging a Code P0327 on a LS6 Lingenfelter motor. I am assuming that PID ESC1DNL is for the front KS and used with P0327....
Data logging shows very low counts on sensor 1 "Front?" (8 to 10 range) and higher counts on sensor 2 "Rear?" (120 to 180 range). This under light loads around 35 MPH in 4th gear.
It would seem based on the data that the code is caused by a faulty front sensor because the counts are so low. I swapped connections between the sensors and the "low counts" reading moved to sensor 2. This would tell me that it is not a faulty ECM or wiring from the sensor to the ECM.
Sound about right....I want to be sure before I have to pull the intake and change the sensor.
Thanks.