2002_z28_six_speed
September 14th, 2007, 08:45 AM
I have some K type probes. On the V2 module do you have to have a sender to use the probes?? I don't have a sender but was wondering if the device could be interfaced with the EGT plug without a sender being required.
If not I guess I should be able to plot the resistance vs Temp with my laser gun and make a PID. What do you guys think?
I wish there was a simple circuit you could build to make this possible but I can't think of anything ATM.
NM. I am a n00b. I think an isolation transformer for signals would work. :-X
If not I guess I should be able to plot the resistance vs Temp with my laser gun and make a PID. What do you guys think?
I wish there was a simple circuit you could build to make this possible but I can't think of anything ATM.
NM. I am a n00b. I think an isolation transformer for signals would work. :-X