PDA

View Full Version : moving to co3



stigmundfreud
October 3rd, 2007, 11:35 AM
I'm considering moving to CO3 once I have my tune sorted out. I understand that the ve table switches from rpm vs map to ect vs map. Is this so and if so will it need me to redo my ve table?

I'm planning the move to possibly go semi open loop so I can ditch the ltft and just run commanded on all but where I call for 14.7 (probably just the idle cells). I know the os is noted for SD but as I plan to do some cross alp passes I was hoping to run the MAF.

Will CO3 work well with the MAF?

5.7ute
October 3rd, 2007, 11:48 AM
It is your commanded fuel table that changes axis not your VE table. B3605 which runs off ETC/RPM is no longer used & is replaced with B3647 which runs off MAP/RPM.

joecar
October 3rd, 2007, 11:49 AM
No... I believe B3605 ECT vs MAP becomes B3647 RPM vs MAP... the VE table B0101 stays the same.

MAF should work with COS3.

stigmundfreud
October 3rd, 2007, 12:58 PM
sweet

anyway before then I have hte pressing issue of smoothing out my ve and pray my lc-1 holds out. Oh for the digital input too...