need help tuning

[joe'sls1]

i have a tune file that i have attached for speed density it dose not work now it will not read properly for scan tool and to pase and multiply. i putin the fast cal file but does not work. also when it runs normaly it runs 14.7 wich is lambda but when i hit to the floor it goe to 9.8 way rich andi cant change a thing because im lock out offthe system this is verry fustrating and wont work


attached tune file

if you can mod this file send to me @ the two addresse

stp@bellnet.ca
transam2008@hotmail.com

[VT LS1 NZ]

i have a tune file that i have attached for speed density it dose not work now it will not read properly for scan tool and to pase and multiply. i putin the fast cal file but does not work. also when it runs normaly it runs 14.7 wich is lambda but when i hit to the floor it goe to 9.8 way rich andi cant change a thing because im lock out offthe system this is verry fustrating and wont work


attached tune file

if you can mod this file send to me @ the two addresse

stp@bellnet.ca
transam2008@hotmail.com

Ive modified your file for COS 2 and sent to top email address.
Follow the advice already given and in the email I sent a weekago.
Validate the pids.
Right click on the pid then click more info that should steer you in the right direction.
Also click F1 reading the user manual again might also help.

Darren