PDA

View Full Version : E38 P3001 Dtc ?


Bob's Garage
October 15th, 2007, 05:56 AM
I have recently installed an APS TT on an 06 C6.

I am getting the SES light and the code is P3001 (not P0301)
I cannot find any reference to P3001


Any help?

Bob
Redline Motorsports
October 15th, 2007, 01:08 PM
:nixweiss:
GMPX
October 15th, 2007, 02:45 PM
That is rather odd indeed, there is no reference at all to a code P3001.
Got me beat too!
Does it have any odd effect on the car or just the MIL on?

Cheers,
Ross
joecar
October 15th, 2007, 03:12 PM
P0xxx = generic code
P1xxx = manufacturer specific code
P3xxx = ?
Blacky
October 15th, 2007, 03:24 PM
The range: P30xx is listed as "Fuel and Air Metering and Auxilliary Emission Controls".

Have you still got the code on your C6? If so, please start the scah tool software, and display the code. Then generate a user error report and send that to me at paul@efilive.com

Regards
Paul
Bob's Garage
October 16th, 2007, 10:45 PM
Paul

Email sent ---- Thanks

Bob
Blacky
October 17th, 2007, 08:10 AM
I have not received any email yet.
Regards
Paul
Bob's Garage
October 17th, 2007, 08:15 AM
Paul - just resent to both paul@ and support@efilive.

Thanks again for checking this out.

Bob
Bob's Garage
October 17th, 2007, 11:18 AM
Paul
Thanks for resolving this issue.
I am all set.

Bob
Gonz
February 14th, 2008, 03:02 AM
Bob,what did you find out?I have the same code on a 06 silverado LS PCM
Redline Motorsports
February 14th, 2008, 03:40 AM
This was an internal issue with the OS if I remember correctly as we tuned the car. I would contact Paul or Ross to see.

Send it to support@efilive.com

Howard
Bob's Garage
February 14th, 2008, 04:18 AM
Gonz
Thinking back... it was corrected by EFIlive.
Blacky created a new calibration, I loaded it or something and it went away.
It was a false DTC

Check with him.


Bob
Gonz
February 14th, 2008, 06:05 AM
Thanks BOB,this issue started about the same time I updated the firmware the other day.I also have been getting codes c0035 c0044 wheel speed codes,now thoses have been coming on for sometime,those I thought could have been tied to when the truck had a front wheel bearing replace under warrenty.I had noticed it after that time.Althought everything works fine.
Blacky
February 14th, 2008, 07:41 PM
I'm sure that problem is fixed in the latest 7.5.3 release along with the FlashScan V2.4.70 firmware. Are you running those software versions?

P.S. Please note the standalone DTC display in FlashScan still has the B and C codes swapped around as per this thread.
http://forum.efilive.com/showthread.php?t=7338
That will be fixed in the next firmware update.


Regards
Paul
Gonz
February 15th, 2008, 09:45 AM
Yes I have 7.53 , I had to update both firm and USBs after loading 7.53 I reflashed it today and now I am getting
(4) P2A0l 02sensor codes
and c0040 and c0035