Dale
October 22nd, 2007, 02:41 PM
ok, this is the first time I have ever tried to edit anything on any car computer. Beyond total newb. I do see I need to find a "PCM Editing for Dummies" book as about half of this I was confused. :muahaha:
Anyway, this is my first attempt at the basic stuff, just to get the car to start and as few trouble codes as I can on first try. Id like for a few people to view what Ive done and tell me if they see something I missed, should have on, shouldnt have on, etc. :help2:
Details of car are below that I think are needed for review :
91 Camaro
350 block
810 swirl port heads
TPI intake unmodified
stock mangled exhaust
unknown non-roller cam with quite a bit of valve overlap(it lopes decently)
22lb injectors
dual electric fans
does have egr, map, maf, evap, purge, all hooked up.
t5 manual trans
3.23 rear axle
235/55/16 rubber
using '02 L31 van bin on the 0411 ecm.
car will be mostly intown stoplight to stoplight. Occasional hwy and 1000ft dashes.
things I know I played with:
1. vin code
2. speedo/axle/tire size
3. fans turned on, #1 kick on at 190,off 185, fan2 195/185
4. Class 2 theft off (later will attempt to connect to factory PWM)
5. post cat o2 sensors off
6. delete all automatic stuff, try to let it know its a standard
7. fuel tank pressure stuff off.
Do I need to make "B0104" cylinder volume 1000 rather then 713?
Since I'm standard, how does it know what gear I am in for rev limiter?
All help will be greatly appreciated!!
Dale
Anyway, this is my first attempt at the basic stuff, just to get the car to start and as few trouble codes as I can on first try. Id like for a few people to view what Ive done and tell me if they see something I missed, should have on, shouldnt have on, etc. :help2:
Details of car are below that I think are needed for review :
91 Camaro
350 block
810 swirl port heads
TPI intake unmodified
stock mangled exhaust
unknown non-roller cam with quite a bit of valve overlap(it lopes decently)
22lb injectors
dual electric fans
does have egr, map, maf, evap, purge, all hooked up.
t5 manual trans
3.23 rear axle
235/55/16 rubber
using '02 L31 van bin on the 0411 ecm.
car will be mostly intown stoplight to stoplight. Occasional hwy and 1000ft dashes.
things I know I played with:
1. vin code
2. speedo/axle/tire size
3. fans turned on, #1 kick on at 190,off 185, fan2 195/185
4. Class 2 theft off (later will attempt to connect to factory PWM)
5. post cat o2 sensors off
6. delete all automatic stuff, try to let it know its a standard
7. fuel tank pressure stuff off.
Do I need to make "B0104" cylinder volume 1000 rather then 713?
Since I'm standard, how does it know what gear I am in for rev limiter?
All help will be greatly appreciated!!
Dale