where is my timing?

[Cablebandit]

COS5.....Under boost lets say i have 25 deg in my high/low octane table.....and at 10psi i tell it to pull 10 degrees via the boost timing table. well i SHOULD have 15deg of timing but instead i will have 11.5-13.5 No knock retard and i cant find anything else that can pull timing. i have zerod out the iat and ect timing maps.......any idea?

[SSpdDmon]

Burst knock can pull timing. Try increasing the burst knock delta table from the factory 0.02 grams/cylinder to .04~.05 grams/cylinder.

[Cablebandit]

shouldnt burst show up as knock retard though?

[kbracing96]

shouldnt burst show up as knock retard though?

No, it's a different PID. Log ALL your timing PIDs and see which one is pulling your timing.

[Cablebandit]

i think you guys have found my timing. In the area where its missing, it matches up to the burst knock table. thanks!!

[SSpdDmon]

:D Welcome.

[Cablebandit]

that was it!!!