AutoVE & COS3 tuning...Q's.......

[WHYTRYZ06]

Ok going to do an OLSD tune on the new motor... The question is.....

When we 1st start up the motor what should I do..... Kinda lost there, I wanna break in the motor right... I plan on doing OLSD w/ COS3... No PE, fueling will be controled through table B3647. Do I set B3647 to 14.63 afr from 20kpa-95kpa & 0rpm-7200rpm... I guess I would want the motor to run stoich on 1st startup, right???

Will the motor run at stoich if I set B3647 to 14.63afr as I stated above???

When should I do AutoVE??? After Ive broken in the motor???

Basically I wanna know how to tune the car w/ COS3 and AutoVE when we 1st start up the motor...

Ive read the AutoVE tutorial, so I got that down..

Anyone have any ideas???

THANKS

[oztracktuning]

Make sure the cells from 80Kpa upward are richer than stoich. You do need it to be 12.5-13.0 AFR at full load.

[WHYTRYZ06]

Make sure the cells from 80Kpa upward are richer than stoich. You do need it to be 12.5-13.0 AFR at full load.

Ok I had that in mind... That new table is gonna be the shit w/it being via rpm.

ANYONE ELSE???