PDA

View Full Version : Logging with PC after upgrade to BBL



Lennart
November 25th, 2007, 09:47 AM
I upgraded to the BBL firmware and 7.5.1RC1.
Since the BB logging did not work for me I decided to do it as usual with my laptop hooked up.
For some reason I now have 3-4 frames in a .1-.2 sec. sequence followed by a .8 sec logging gap.
I never had that issue before....with 7.4.2
Running XP SP2 with a very old USB driver as all newer ones did not work.
How do I find out which driver I have installed?

Blacky
November 26th, 2007, 01:57 PM
The new signed drivers will work - as long as you remove the old (unsigned) ones completely.

To do that, use the FTClean utility here:
http://www.efilive.com/download.aspx#downloads5

Use the Product ID (PID) value E4A1 to clear ONLY FlashScan V2 drivers.

Then re-install the drivers using the files in the folder:
\Program Files\EFILive\V7\EFILiveUSB
These drivers would have been saved on your hard drive when you upgraded to V7.5.

To find out what version you are using open the "My Computer->Properties" window (shortcut key = Windows+Pause/Break). Then follow the circled actions in the attached image. (Note: FlashScan must be connected or you won't see it in the USB list).

Regards
Paul



Regards
Paul