PDA

View Full Version : Updating to BBL Firmware problems



WildChild
November 25th, 2007, 04:32 PM
I have downloaded and extracted everything properly (I think) but when I go to run the EFILive explorer and click on Flashscan V2 it says its not connected and I have tried in and out of dead poll mode????
Help please:frown:

Blacky
November 26th, 2007, 01:48 PM
Make sure the Scan and Tune tools are not running and try again. If that is not the problem, start the EFILive_Explorer program and click on the [FlashScan] button to attempt to connect to FlashScan, then...

1. Show the EFILive_Hapi program (i.e. right click on the FlashScan icon in the system tray at the end of the Windows Task bar, and select Show).

2. Goto the Connections->Settings page and make sure FlashScan is checked and AutoCal is unchecked, (unless you are beta testing AutoCal as well).

3. Goto the Trace->Settings page and check both check boxes and set Size to 10000.

4. Goto the Trace page and click [Clear].

5. Goto the Settings page and click on the [Status] button. You should see two green ticks under USB and CNX.

If not, go back to the Trace page and click [Save]. That will save the entire trace - not just tha last 20 lines that are displayed on that page.

Check the error numbers in that file with the error descriptions here:
http://forum.efilive.com/showthread.php?t=6732

If it is still not clear what is causing the problem, send the file to me at paul@efilive.com

Note: When you have done all this, uncheck the checkboxes in step 3 to turn off tracing.

Regards
Paul

WildChild
November 27th, 2007, 09:04 AM
I must have a problem with something else, I dont have a flashscan icon in the task bar and when I go to the hapi file and click on it to open it will show on the task bar for a moment and go away:frown:

Blacky
November 27th, 2007, 09:12 AM
See post #44 in this thread:
http://forum.efilive.com/showthread.php?t=6724&page=5

Regards
Paul