V2 flashscan with LM1

[Xtnct00WS6]

Can someone point me in the right direction for a step by step guide to install the LM1 with Flashscan V2?

What should the log works settings be on each tab?
Is it? :
0 Volts to be 7.35 AFR.
5 Volts to be 22.35 AFR

When these settings are saved, it jumps to 4.996 volt at 22.34 air-fuel-ratio. Is that normal?

Whats the difference between analog out 1 and analog out 2? How do I know which one I'm using? Should I set them both up the same?


Thanks!

[TAQuickness]

Should be a similar install as the LC-1 tutorial found in the scan or tune tools Help menu.

[Aint Skeered]

I would like to know also. I dont want to replace my nbo2 , I just want to hook my lm1 into my v2.

I may not be reading it right but on my analog cable with the lm1, there is a red, white and a brown wire. where would these hook up?

[Slowrc]

Should be a similar install as the LC-1 tutorial found in the scan or tune tools Help menu.

Can someone give a hand for a dummy. I am needing to hook up my V2 to a lm1 and a lc1. Its so simple most post skip over it and go straight to installing software. Also, an explanation of serial verses analog would be great. I would love to do this ONCE.

THANKS in advance!!!