WBO2 controller

[Thumper]

I am new to EFi live and looking for a WB02 sensor setup. The Manual says I need a 0-5v AFR output from the WB controller.
I am Struggling to find one where I am, and was wondering if this would do the job.

http://www.precisionrace.co.za/content/zeitronix.html

Would the AFR outputs work with the flashscan interface.

Looking forward to learning more about tuning from you guys!
Im sure you will be hearing from me quite often.

Happy motoring!

[mr.prick]

Input/Output range
Lambda 1.43 to 0.64 Wideband
AFR 21.0 to 9.5 Wideband
Vacuum 650 mmHg
Boost 2.4 BAR
EGT 200 C - 1200 C
Analog Wideband Output 0 - 5V
Throttle Position 0 -100 %
RPM 0 - 14,000
User Input 0 - 5V

looks like it will.
and it is priced nicely.

[Thumper]

Thanks for the reply. Spent so much time breezing over units, that I missed that bit. I supposed I helps to read closer doesn it. :)